HomeMy WebLinkAboutBLD02-236Building and Community Development
Watennen&Katz Building
181 Quincy Strcet Suite 301
Port Townsend WA 98368
Ptwne: (360) 379-3208 Fax: (360) 385.7675
CITY OF PORT TOWNSEND
CONSTRUCTION PERMIT & INSPECTION RECORD
THIS CARD MUST BE POSTED AT CONSTRUCTION SITE
Ca11385-2294 for Inspection
Permit Number: BLDOZ-236 Issued: 10/11/02 Parcel Number: 955 900 006
Owner/Contractor: Hamilton Heiehts LLC Installer: Kozeliskv's Home Services WAINS0626
Job Address: Lot 6: 2366 Rainier Street Zoning: PUD Type: VV=N Occupancy: R-3/U-1
Total Occupant Load: 4t2 Nature of Work: Set Manufactured Home with attached site-built earase.
porch and deck.
GENERAL CONDITIONS APPLY -SEE LAST PAGE
SEPARATE PERMITS REOUIIiED:
Electrical -Contact Labor & Industries @ 360-417-2702
***Hours of Construction are limited to 7.•30 am. to 6:00 p.m. Monday through
Frfday and prohibited on weekends and national holidays***
REQUIRED INSPECTIONS
APPROVED/DATE
TEMPORARY EROSION & SEDIMENT
CONTROL
See details attached to MIP and general condition #2
Silt Fence
Drive Off Mat
SLAB/CONCRETE
Setbacks ~1
tl~~ ~//
f/
~~~~61~1~ (_
Forms
Monolithic Slab/Foundation (garage) /'
CiJQ/JB.f Q I
/J/f
w/ ~/OL
Reinforcement _ ~' " ` j
Anchor Bolts
Deck Piers
Alternate Braced Wall Panel Holdown Hardware
LIFER
Ca1148 hours before you dig for utility Iine locates
1-800-424-5555
Page 1 of 4
Pemtit # BLD02.236
r~
L
•
REOUIItED INSPECTIONS APPROVED/DATE
PLUMBING (prior to skirting)
Water Supply -Main shut-off valve (port or ball valve)
installed in water supply piping prior to connection to home,
min. 3/."diameter, same as supply pipe
Pressure Reduction Valve if> 80 psi
Hose Bibs (backflow protection required)
Pipe Insulation -Outside & in crawl space
Pressure Test - ]00 p.s.i. for IS minutes
Pressure relief valve drain - to exterior of skirting, exhaust
dowmvard between 6"and 24"above ground
Drainage Piping -sloped min. %,"per foot
MECHANICAL (prior to skirting)
Ducts & Duct Insulation
Dryer Exhaust -vented to outside. Extension into crawl space
requires venting through skirting with no dips; follow dryer
manufacturer's instructions; total combined length of ducting
not to exceed 14' w/2-90° elbows
FLOOR FRAMING (prior to skirting)
Anchors
Steel Support Piers -Load-stamped and installed per
marmfacturer's installation manual; clearance of 18"min. from
lowest point of I-beam and the ground or footing for min. of
75% of area under home w/ I2"min. elsewhere unless
installation manual species; otherwise area around home
graded to provide runoff away from home.
FRAMING:
Engineered roof truss plan to be on-site at time of inspection
Walls
Alternate Braced Wall Panels
Header
Roof
Garage/House Attachment
DRY WALL NAILING
Garage/House Occupancy Separation with 20 minute
self-closing door
Call 48 hours before you dig for utility line locates
1-800-424-5555
Page 2 of 4
Permit # HLD02-236
FINAL
Public Works Sign-Off
Electrical (L & I) Sign-Off
House Number -minimum 5" numbers
Plumbing
Mechanical
Deck
Pressure-Treated Framing
Positive Connections
Final -Building
n -~f ~, .
~r`" ~~1 rrh"`
No holes or gaps greater than '/. "allowed
in skirting. Skirting to be rated for contact with
earth if back~ll is involved.
Crawl space ventilation per installation
manual @ 1 sq. ft./150 sq. ft. (13 req'd.);
located close to corners, on at least two
opposing sides for cross ventilation.
Crawl space access must provide access to
all areas under home; minimum IS"x 24"
unless specified otherwise; covered with vinyl,
pressure-treated wood or metal.
•
GENERAL CONDITIONS
I. Contractors working on this project are required to have a Labor & Industries contractor's
r~istration number and a Ciri business license. Failure to provide proof of this documentation prior to
work may result in job shut down while this is accomplished.
2. Temporary erosion and sediment control (TESC) measures shall be installed on-site and inspected
prior to beginning construction; ca11385-2294. Measures shall include installation of silt fencing and
graveled construction entrance (see attached details). Soils exposed during construction shall be
temporarily stabilized with mulching, plastic sheeting, etc. Soils shall be permanently stabilized with
seeding, plantings, sodding, etc. once construction is complete. Applicant is responsible for protection of
adjacent properties.
3. All elements of engineering including nailing, holdowns, sheathing, and alternate braced wall panels
(ABWP) require inspection prior to cover.
4. Owner or owner's agent shall review and oversee correMion of any and all deficiencies noted by
required inspections.
5. Re-inspection is required after any corrections are completed.
Call 4S hours before you dig for utility line locates
I-800-424-5555
Page 3 of 4
Pertni[ # BLD02.236
- 6. The Building Department is unable to pass final inspection on your project until Public Works
requirements have been completed and inspected. For Public Works inspection call 385-2294; a
minimum of twenty-four hours notice is required. Public Works approval must be received prior to
scheduling the Building Department's final inspection.
7. Final Inspections and Certificate of Occupancy are required PRIOR to occupancy.
8. All building permits expire if no progress has bE
done by the Building Department within one year.
building permit active.
en made within siz months, or if no inspections are
Call for at least one inspection per year to keep your
9. Revisions require review and approval prior to making changes in the field. Contact the Building
Department 379-3208 prior to making changes to the approved plans.
10. POST THIS PERMIT ON-SITE WITH THE APPROVED PLANS.
•
C~
Ca1148 hours before you dig for utility line locates
1-800-424-5555
Page 4 of 4